I) Check to ensure that cut-out devices for all the fuel injection pumps are correctly positioned for normal fuel pump operation and that the exhaust valve actuator pumps are also ready for operation, i.e. H) Check to ensure that all the crankcase doors are closed with all the latches tight. Operate the cylinder pre-lubrication system. Check if any water, oil or fuel has collected on the piston crown. #MARINE ENGINE SIMULATOR FULL#Using the turning gear, turn the engine through a minimum of one full revolution to check that all the running gear is in order. G) Open the indicator cock on each cylinder cover. Preheat the cooling water to 60☌.į) Check to ensure that all systems have been correctly vented and that there is a positive flow of cooling water and lubricating oil. ( Note: Valve numbering refers to those in the engine manufacturer’s manual.)Ī) Check the fluid levels of all the tanks in the engine systems including the leakage drain tanks.ī) Check that all the shut-offs for the engine cooling water and lubricating oil systems are in the correct position.Ĭ) Open the air supply to the shipboard system and from the starting air receivers to the control air supply.Į) Start up the pumps for cylinder cooling water, crankcase bearing and crosshead bearing lubricating oil and set the pressures to their normal values. Before starting the engine, the following checks and procedures must be followed:Īll components that have been overhauled should have been correctly reassembled and fitted and their function checked.Īll devices and tools which were used, have been removed from the engine and that no cleaning rags or other items have been left behind.ĬAUTION Up until item ‘m’ below, the air shut-off valve for starting, 2.03, must be closed and the venting valve 2.21, on the side of the shut-off valve, must be open.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |